VAG 27.4

ABRITES Diagnostics for VAG is a Windows PC based diagnostic software. This Commander (with the AVDI) allows you to perform operations to vehicles within VAG, which are largely unsupported from the manufacturer's diagnostic testers. Dealer keys preparation, key programming for Audi R8, Q7, A6, Allroad, TT, VW Passat CC, Crafter...

This  VAG Commander  also provides full diagnostic capabilities for vehicles from Volkswagen Audi Group. Supports mileage recalibration, PIN code reading, component security authorization, programming of immobilizers, key programming, EEPROM R/W, flashing of ECUs, TV Activation etc. Preparation of dealer's keys ... and all this by OBDII.

Standard Diagnostic Functions:

Connect to the device using KWP2000 over TP2.0, KWP2000 over TP1.6, UDS over ISO transport protocol (CAN), KWP1281 or KWP2000 over K-Line

For all electronic control units reading identification data

For all electronic control units read error (DTCs)

For all electronic control units clear error (DTCs)

Scan all units

Broadcast requests

Measured values


Read/Update of flash memory (EDC15, EDC16 all types Read/Update Flashmemory via OBDII (K and CAN). Calculation of checksums while programming, ME7.1.1, MED9.x, ME7.5). Read/Update flash counters (EDC16)

PIN Convertor

TV Configuration ED1/ED2
- Using this special function you can change speed limit of MMI compatible vehicles to change speed where the TV is turned OFF

Dump tool - With this function you can calculate security access codes, calibrate and so on from dump from the corresponding unit

Service interval - Using this function you can perform reset of the service reminder, reset of the service interval parameters or change service interval options

Service intervals -reset for the models with UDS diagnostics

Remote control adaptation - Using this application, you can learn remote controls

Navigation - Using this application, you can enable/disable the “Eject” button of the “Navigation” system

Cruise control system - Using this application, you can activate/deactivate a cruise control system and change the related steering wheel electronics( SWE) configuration if SWE unit is available

Brake pads change - Using this application, you can “Open rear parking brake for pad change”, “Close rear parking
brake”, perform “Parking brake function test”

Steering Lock adaptation - The window “Steering lock adaptation” can be used for adaptation of steering lock control module to the VW Touareg/VWPhaeton/Porsche Cayenne/Bentley Continental/Audi A8. This adaptation can be by CAN TP2.0 or K-KWP2000

Items 1 to 15 of 16 total

  1. 1
  2. 2