VAG 41.4

- BCM2 Solder Free Connection Set

This function enables:

- Extractiion/read/update/program   and display  immobilizer related data by diagnostic

- Airbag functionality

- Preparation of a key ready for adaptation by diagnostic to the vehicles with BCM2

- Component protection generation

- Adaptation of engine control units to the vehicle

Function requires internet access

Function includes AN043, AN045, AN046, AN047, AN048, AN049, AN052, AN053, AN055, AN056, AN057, AN058.

Discounted update to VN002 avaiable to existing users with any of these functions. Submit a ticket with a screenshot of VAG licence viewer to access pricing.

This function enables:

- Extractiion/read/update/program  and display immobilizer related data by diagnostic.

- Extract and display PIN code.

- Key programming and adaptation.

- Emergency start for engine control units.

Function requires ZN003 PROTAG V2.

Function includes AN043, AN044, AN045, AN049, AN050, AN059.

Discounted update to VN003 avaiable to existing users with any of these functions.

Submit a ticket with a screenshot of VAG licence viewer to access discounted pricing.

The function allows to replace immo-related parts in another vehicle, even when the brand is different or the power class is different.

VN005 is intended for use with cars that don't allow writing PIN,CS,Power Class and any immo data in the ECU/TCU. 

These models are different, such as Audi A8,A6,A7 Q7, VW Phaeton and Bentley

The function requires internet connection and a complete VN002.

VN005  requires ZN052 cable set that enables you to start and complete the operation. Each module  adapted (TCU or ECU)  requires an EM003 emulator to be built inside the car.

VN006 enables programming of keys to Immo III/IV vehicles with Megamos48 keys. Using this function, along with 
the ZN053 adapter and  ZN051 Distribution Box (both sold separately), you have the ability to program keys both when there is a working key and in ALL KEYS LOST situations.

ZN053 adaptor required

ZN051 required

This function enables cluster recalibration for a number of  MQB models fitted with a Continental/VDO instrument cluster.

This function require internet connection and active ASSIST PLAN. 

This function enables key programming for a number on MQB platform from 2012 onwards fitted with Continental/VDO instrument cluster. 

Currently a working key is required to be present to enable  key programming

VIN ordered keys or blank genuine keys can be used.

N.B. Currently vehicles fitted with a virtual cockpit system are not covered.

This function require internet connection and active Assist Plan

ZN003 PROTAG V2 required for key progamming

This function will allow customers to perform module adaptation (for immo parts) and key learning (both adding key and ALL KEYS LOST) by reading the security data (PIN and CS) of the 9GV ECU

The function allows the customers to perform authorization (using the ZN051 Distribution Box) of the vehicle ECU in order to update the engine software or to start the vehicle.

This is done in order to enter into reflashing mode to update the software with a SGO/FRF file or to perform an emergency start to the vehicle so that it can be driven to the next service point.

 Mileage recalibration for VAG vehicles excluding MQB Vehicles

Includes

- VN003

- VN006

- VN009

- VN020 

Includes

- VN002

- VN003

- VN005

- VN006

- VN007

- VN009

- VN012

- VN013

- VN015

- VN017

- VN018

-VN020